Hello everyone. ------ Off topic -------- Before we start, is there possibility to change display size of attached images ? Or at least format them so they are shown vertical not horizontal like now? ------------------------ Yeah. I barely survived my Cain some time ago. Still haven't finished it because I still haven't recovered fully . I'm slowly (VERY slowly) starting to think about coming back to finish it. I thought that I come and share couple of my pictures since I'm here. As a reference I used all the images I could find. I tried to be true as close as I could to the big Cain model that they used in movie, for example in the shot where Cain and Robocop fell from building and they lay together in the basement. In this shot big cain model was used it is a lot more detailed than the small figures that where used for animation so for example fingers looks different and have a little more rounded corners than small figure. I see you made the same mistake as most daredevils out there and made arm cylinders the same size. Look at the picture, do you see the diference? This shot shows it even better. I hope I didn't brake you down. You don't have to start from scratch . Here are couple older shots, they show close-up's of some other parts: https://www.3dbuzz.com/forum/attachme...5&d=1286023264 https://www.3dbuzz.com/forum/attachme...8&d=1286293725 https://www.3dbuzz.com/forum/attachme...0&d=1286749495 https://www.3dbuzz.com/forum/attachme...4&d=1283550861 https://www.3dbuzz.com/forum/attachme...9&d=1283819053 Here is shot of the cylinders before I remade them so they would not be the same size : https://www.3dbuzz.com/forum/attachme...0&d=1283269664 I also started to rig it a little, trying to automate it as much as I could so I don't have to rotate each hinge myself. In this video, after hexapod rig, there is example of right side hands rig and also main body hydraulics. And here are shots of this model in its current state: