Hi Dave

Thanks for your reply. I had thought of that. But the design on top of which i'm trying to model has a lot of sharp corners and overlapping curves which cause the subsequent over lapping lattices created by the flow motion path to deform the geometry in crazy ways. See my image attached for an idea of what i'm trying to achieve. I want the final logo to look like it was created out of rolled out paper, similar to a quilling technique. I am trying to get tightly rolled up geometry to fold out along the curves in the image to reveal the logo. In fact the bend deformer does not seem up to the task as I cannot get tight enough rolls. It funny, I'm really shocked at how difficult this relatively simple idea seems to be.