Now my problem is that.. I am following to the steps to move the pivot point of the head to the base of the head and it's not working.. and its pissed me off so much i've started on other projects... can Someone please tell what what im doing wrong??Bind the head into the skeleton, you will constrain the heads position and orientation to match the skeletons top joint
These are the steps I follow:
1.Select the head surface 2.Select Modify >Center Pivot 3. Select Move tool 4. Press the 'insert key" 5. Move heads pivot to the base of the head 6. Press 'insert' key
**I can never get past the 4th step because unless im dense or something... the object doesn't go into edit mode and I just end up moving the whole head instead of the pivot point... over and over.. :angry: **
Thank you for whatever help you guys/gals can offer me!!
Here we go. Let's run a check first to see if the insert key is functioning correctly. Make a cube > select the W hot key for move>select the insert key to enable edit pivot point>grab the yellow square with the dot in it and try and move it in the front, top, or side views>then select insert key to disable edit pivot point. If this works then Maya is configured properly and there is something else wrong, But if this doesn't work then give this a try.
