Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
When you are about to dublicate (and making sure that your pivot point is at the right place)....go into edit...duplicate options....make one of the scales -1 (it depends what way you want to duplicate...normally it's either -1 in x or z)...and to get it so that when you change one thing on one side and it applies it to the other...you have to select "instance" in the geometry type
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off