Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I'm new to this forum so please forgive me if I don't post this question correctly. As I posted in the Subject header I'm having problems converting NURBS to Polygons in the ninja tutorial. I have searched the previous posts and found others have posted similar problems. I have tried the advice offered but continue to experience the same problems. I have included the error and a copy of the file in case someone would care to have a look.
Any help would be greatly appreciated. - Thank you very much