Using curves to create 3D

Beer glass scene creation

This course contains a little bit of everything with modeling, UVing, texturing and dynamics in Maya, as well as compositing multilayered EXR's in Photoshop.

Watch

# 1 31-05-2006 , 05:30 PM

Registered User
Join Date: May 2006

Location: Bath, England

Posts: 16

Hi,

I am trying to make a logo 3D.
I have put an image of it on the image plane and traced the edges with the EP curve tool.

How do I now make it 3D??
i.e. Add surfaces to it?

Thanks,

Very Stuck!

Attached Thumbnails

Knowledge is knowing a tomato is a fruit; Wisdom is not putting
it in fruit salad.

Quote

# 2 31-05-2006 , 05:49 PM

Subscriber
Join Date: Mar 2005

Location: London

Posts: 1,135

lots of options
1) duplicate and move up to desired height and loft between each set of 2 cures

2)use bevel plus tool and tweak with the settings

Now at SMU doing BSc 3D Computer Animation so its hard to get on here
My wire render tut https://forum.simplymaya.com/showthre...threadid=20973

Quote

# 3 31-05-2006 , 05:56 PM

Registered User
Join Date: May 2006

Location: Bath, England

Posts: 16

Thanks

Hi,

Thanks for your reply.

The loft worked but now I need to somehow create a surface.
See attached Images.

Thanks.

Trying to get this-

Attached Images

Knowledge is knowing a tomato is a fruit; Wisdom is not putting
it in fruit salad.

Quote

# 4 31-05-2006 , 05:58 PM

Registered User
Join Date: May 2006

Location: Bath, England

Posts: 16

From this:-

(minus the writing)

Attached Thumbnails

Knowledge is knowing a tomato is a fruit; Wisdom is not putting
it in fruit salad.

Quote

# 5 31-05-2006 , 06:56 PM

Subscriber
Join Date: Mar 2005

Location: London

Posts: 1,135

ERMM CANT REMEM OFF THE TOP OF MY HEAD

select the outside curve then all the urves inside - the do a planar operation (surfaces -> planar)
then do same for the bottom now u should have a top and ottom in 2 operations good luck

Now at SMU doing BSc 3D Computer Animation so its hard to get on here
My wire render tut https://forum.simplymaya.com/showthre...threadid=20973

Quote

Reply to this thread