merging multiple points?

Maya 2020 fundamentals - modelling the real world

Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.

Watch

# 1 06-02-2007 , 07:52 AM

Registered User
Join Date: May 2006

Posts: 64

I have to meshed I basically want to merge with a mirrow image of it. Normally I go point by point but this is detailed. The merge edge tool allows one edge at a time, and the merger allow one point at a time. Is there a way to say merge to closes adjacent point?

Quote

# 2 06-02-2007 , 08:45 AM

Senior Software Developer
Join Date: Jan 2005

Location: Livingston, Scotland

Posts: 1,701

The Merge Vertices Tool, will allow you to select and merge multiple vertices at one time. Be careful, if the setting is not right when you click it, then you may have quite a few un wanted merges.

Chris (formerly R@nSiD)
Twitter
When the power of love overcomes the love of power the world will truely know peace - Jimmy Hendrix

Winner SM VFX Challenge 1

3rd Place SM SteamPunk Challenge (May 2007)

Quote

# 3 06-02-2007 , 11:03 PM

Registered User
Join Date: May 2006

Posts: 64

If I use edit mesh -> merge, and hit apply nothing merges. If I select two points I get a good merge. If the thresh hold is adjusted in the slightest bit all points merge to one.

Quote

Reply to this thread