Door Detail

Digital humans the art of the digital double

Ever wanted to know how digital doubles are created in the movie industry? This course will give you an insight into how it's done.

Watch

# 1 12-12-2007 , 11:44 PM

Subscriber
Join Date: Nov 2007

Location: Lincoln, United Kingdom

Posts: 40

Hey again,

My project isn't going to bad just another question for you all. I'm making a door got the basic shape, door knob etc. I'd like to add some more detail like the doors in the picture supplied. How would I go about doing that?

Attached Images

Quote

# 2 12-12-2007 , 11:46 PM

Subscriber
Join Date: Nov 2007

Location: Lincoln, United Kingdom

Posts: 40

When I say detail I mean indentations

Quote

# 3 13-12-2007 , 02:33 AM

Subscriber
Join Date: Jul 2006

Location: London

Posts: 567

You would either wanna do a boolean on them, or alternatively and possibly less complicated, just extrude the faces in/out and scale them to whatever size you like.

Chris

Quote

# 4 13-12-2007 , 02:55 AM

As Zbrushiac sounds stupid!
Join Date: Nov 2007

Location: Derby

Posts: 1,241

You could model it in Sub-Ds, it wouldn't be too complicated, but it would be very time consuming, and the door would end up being very dense and unpractical. Your best bet would be to go with a Displacement map.

Good Luck!

www.stevenegan-cgi.com

"Your weapons are no match for ours! People of Mars, surrender!"
"Um, this isn't Mars. This is Earth."
"Earth? Earth-with-nuclear-weapons Earth?"
"Yes."
[long pause] "Friend!!"

Quote

# 5 13-12-2007 , 06:58 AM

Registered User
Join Date: Dec 2007

Posts: 52

Yah, I would recommend adding more edges (edit mesh > insert edge loop tool) to create the indentation shapes on the surface, then extrude them in and out (moving and scaling as needed) to create the actual indentations (play with the bevel tool after this to help make more rounded edges). I'd recomend against boolians (unless there is no better solution), I personally find they cause more problems then they solve.

Quote