Moving verts with "Insert"

Maya 2020 fundamentals - modelling the real world

Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.

Watch

# 1 26-04-2008 , 09:34 AM

Registered User
Join Date: Mar 2007

Posts: 92

Using Maya 8.5 on Precision 690. OS is XP Pro

When rebuilding polys I will select a series of verts I want to move in unison. I use the insert to move the manipulator to the vert I want to use to direct the transfornm of the whole group of selected verts. Then insert again and I'm good to go.
Moving the verts in this synchronized way works fine, except when I try to snap the "lead" vert to another vert while keeping the orchestrated formation of all the selected verts. When I do this using the "v" key to snap, all the selected verts converge on that snap, not just the vert that I have assigned the manipulator to.

This didn't used to happen.

This operation used to work exactly as I wanted, allowing me to rebuild my polys. However, recently that has changed.

Anyone know how to change it back?

I hope I have described this in a way that others can follow.

thanks. T

Quote

# 2 26-04-2008 , 11:40 AM

Subscriber
Join Date: Dec 2004

Location: Netherlands

Posts: 45

Hi, with the translate tool selected hit the middle button in the top right corner. Under Move snap settings make sure that retain component spacing is selected.

Quote