hi all its been a long time

Maya 2020 fundamentals - modelling the real world

Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.

Watch

# 1 27-05-2008 , 09:13 PM

Registered User
Join Date: Jul 2006

Location: bluemountains Sydney

Posts: 120

i have been working on this just for a little bit obviously but as i have been working last night i noticed that all the vertices had seperated (so that edges ran randomly thru the peice ... as it does not have too much geometry yet it was OK to just methodicly go thru and stitch them back together ... but it leaves me with the question "what did I do to cause it in the first place?"
i have attatched this file just so you can see the way I am working tho i have currently no verts that are unattatched

Any ideas/sugestions would be much apreciated:bow:

Attached Thumbnails

Click image for larger version

Name: fixed verts 280508.png
Views: 256
Size: 94.0 KB
ID: 39156

"Climbing the walls of the 'Uncanny Valley"

Quote

# 2 27-05-2008 , 09:16 PM

Registered User
Join Date: Jul 2006

Location: bluemountains Sydney

Posts: 120

further info that may be relevant

i have just been extruding edges and merging verts. ... this has ment that every now and then I have had to set the Normals to Face
if that helps:bow:

"Climbing the walls of the 'Uncanny Valley"

Quote

Reply to this thread