Nurbs attach curve major Issue HELP

Complex UV Layout in Maya

Over the last couple of years UV layout in Maya has changed for the better. In this course we're going to be taking a look at some of those changes as we UV map an entire character

Watch

# 1 31-01-2009 , 01:03 AM

Subscriber
Join Date: Jul 2007

Location: California

Posts: 180

I am simply trying to make a perfect oval,
•I first make a nurbs circle, set the sweep to 180,
•Then duplicate and rotate, so they mirror one another.
•Then I go to attach curves, then in the att. editor I Change the Method: to connect from blend.

For some reason no matter what I do one side is always not the same as the other. An i need to be able to run a planar command on the curves it wont work unless the lines are perfect...

Please help this is for a school project and Im totally dead in the water. thanks

Attached Thumbnails

Click image for larger version

Name: picture-1.jpg
Views: 329
Size: 46.1 KB
ID: 41329

Bradysammons.com
New Media Designer
Student: Academy of Art University S.F.
My WIP

Quote

# 2 31-01-2009 , 10:53 AM

Maniacal boy king of Babylon
Join Date: Aug 2005

Location: the netherlands

Posts: 1,605

Not sure what the problem is exactly, but i know curves are a bit funky with curvedirection so i would check that first, then i would change the connection method back to connect instead of blend.
If this doesn't work i would cut the curve down the middle delete the half you don't like(the rightside i suppose) duplicate and mirror the half you like adjust the curvedirection if needs be and attach it with a simple connect in the middle .
Also make sure that keep originals is off

good luck user added image