Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I am desperate, I tried to contact the maya people but no answer, my proble is that every time I try to use my extrude polynomial tool Maya shows an error and close the proeegram.
PLease heklp what can I do
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off