problem with curve snaps!

Maya 2020 fundamentals - modelling the real world

Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.

Watch

# 1 14-07-2003 , 08:50 PM

Subscriber
Join Date: Jun 2003

Location: chicago

Posts: 43

lets say i have two curves. one is in edit point mode, and i want to move the point on the edge of this curve so that it touches the other curve.

what do i have to do? what button to push? "c" didnt work.

thanks

visit my site :
www.vhylynx.net

Quote

# 2 14-07-2003 , 08:59 PM

Subscriber
Join Date: Dec 2002

Location: Denmark

Posts: 329

make sure both curves are in edit point mode or control verttex mode... then use the "v"-button for vertex/point snapping.

Kühl

Quote

# 3 14-07-2003 , 09:01 PM

Subscriber
Join Date: Jun 2003

Location: chicago

Posts: 43

but what if i didnt want to snap on any vertex/point? only snap to curve?

visit my site :
www.vhylynx.net

Quote

# 4 14-07-2003 , 09:06 PM

Subscriber
Join Date: Dec 2002

Location: Denmark

Posts: 329

I dunno if you can do this after the curves are already made. I use to snap to curve "c"-button" when inserting the last point of the last curve. This way you can pull the last point to whereever on the other curve ya want...

Maybe somebody else have the answer..

Kühl

Quote

# 5 14-07-2003 , 09:07 PM

Subscriber
Join Date: Jun 2003

Location: chicago

Posts: 43

thanks kuhl.

visit my site :
www.vhylynx.net

Quote

# 6 14-07-2003 , 09:08 PM

Subscriber
Join Date: Dec 2002

Location: Denmark

Posts: 329

no problem buddy...

Kühl

Quote

# 7 14-07-2003 , 11:29 PM

The Maya Mountain
Join Date: Aug 2002

Location: Seattle, WA

Posts: 8,245

Snap to curve is done a little differently than snap to point or snap to grid.

With the vertex or object selected, Hold C, and MIDDLE mouse click and drag ON the curve.

-Mike
The Maya Toolbelt

Quote