:::VENTILATOR:::

Maya 2020 fundamentals - modelling the real world

Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.

Watch

# 1 23-09-2006 , 06:20 AM

Subscriber
Join Date: Jul 2006

Location: Rotterdam, Holland

Posts: 197

I need some help making a vent. It's to incorporate in my assault mech.
Anyone any ideas to make one of these like in a gifffie?

Thx.
M.

too_tough_to_die@mac.com (AIM)
Always up for a chat !

Quote

# 2 23-09-2006 , 06:42 AM

Registered User
Join Date: Jun 2004

Location: Cleveland, Ohio (USA)

Posts: 1,541

well with the kind i'm thinking of it would take longer to explain than to make... i'd take a cylinder, select half the verts (from top to bottom, with half of each cap selected but not the middle vertex from each), offset them a unit or so, then rotate it so it's at a 45 degree angle, duplicate the hell out of it, and then offset each about half a unit or so... the end result would look almost like a set of blinds... is this the kind of vent you have in mind? (making the frame all depends on the shape you want your vent to be so i won't go into too much detail besides making a curve, duplicating it and scaling the duplicate larger, making a loft between the two, and then making an extude using the larger of the curves so it's got depth)

Accept no substitutions.

Quote

Reply to this thread