Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Once you have your tread mesh the way you like it, you can put its pivot point at the center of the tire and use Duplicate with Transform to rotate a duplicate into place. Then using Shift+D, each successive duplicate will be rotated the same amount until you go all the way around.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off