Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I've just modelled them - 50 eyelashes each for upper and lower lids, left and right. Simple polygon geometry. They look ok and intersect with the face geometry.
I was going to try later and wrap deform them to the head, so they would follow the blend shapes for blink etc.
Not too familar with this kind of flow and wondered what you would do - does my idea sound like a good one?
Personally I would just extrude the eyelid (or have one separate piece of geometry) and then use texturing/bump mapping/transparency for the eye lashes
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off