Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
hey can someone tell me how to bend a tube so that the faces point down like the ones that i highlight in the picture? I am modeling in polys, and i can't remember how to extrude it. thank you all!
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off