Ha - I so did this for years - Page 2 - Simply Maya User Community

Introduction to Maya - Modeling Fundamentals Vol 2

This course will look in the fundamentals of modeling in Maya with an emphasis on creating good topology. It's aimed at people that have some modeling experience in Maya but are having trouble with complex objects.

Watch

# 16 01-10-2012 , 03:27 PM

Moderator
Join Date: Jan 2004

Location: Michigan, USA

Posts: 2,998

The Altair 8800 was fun. The switches are for the data address and the machine code instruction. You'd toggle in the address and the machine code and then toggle a write switch to write the instruction to memory. You'd do that for each machine code instruction to write the entire program and then run it. You could save a program out to a gigantic 8" floppy disk. There was a point that I could write entire programs in machine code. Assembly language was for sissy's!

"If I have seen further it is by standing on the shoulders of giants." Sir Isaac Newton, 1675

Last edited by ctbram; 01-10-2012 at 03:30 PM.

Quote

# 17 18-10-2012 , 08:58 PM

Subscriber
Join Date: Apr 2003

Location: Great Britain

Posts: 1,336

What was alot worse than blowing into your cartridges on the SNES was when you stuck your copy of F-16 fighter pilot cassette tape in your commodore 64 (never could afford the disk drive) typed "load" only to find than someone had recorded the sunday top 40 chart off the radio over your game!

Quote

Reply to this thread