Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 14-03-2013 , 05:56 PM
Registered User
Join Date: Feb 2013
Posts: 9

Part of object appears locked when deforming using smooth bind

Hi again...

Another newbie issue...

I have bound two separate joints to a polygon as in the picture below, as a smooth bind. The part on the left rises fine and deforms as expected - but a part of the object on the right is 'glued' to the ground.

What am I doing wrong?

Thanks...

Dan

user added image

# 2 14-03-2013 , 06:00 PM
daverave's Avatar
The thin red line
Join Date: Aug 2009
Location: England
Posts: 4,472
Could you show it in wire mode...............dave




Avatar Challenge Winner 2010
# 3 14-03-2013 , 06:08 PM
Registered User
Join Date: Feb 2013
Posts: 9
You bet... here...

user added image

# 4 14-03-2013 , 06:22 PM
daverave's Avatar
The thin red line
Join Date: Aug 2009
Location: England
Posts: 4,472




Avatar Challenge Winner 2010
# 5 14-03-2013 , 06:48 PM
Registered User
Join Date: Feb 2013
Posts: 9
thanks mate, very helpful indeed.

Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads