Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 08-02-2014 , 01:04 PM
Registered User
Join Date: Feb 2014
Posts: 1

Edge selection issues

Hi guys, I'm pretty new to modeling in 3D and I've run into a bit of a snag. I've added subdevissions to a polygon cube. I want to select the edges and manipulate them. Where as In the past I've been able to select an edge or a series of edges and move them independantly of eachother, now when I select an edge or vertex the selcetion is yellow and a gradient to red indicating influence radiates out from the selection. Moving or manipulating the selection infuliences the suround geomitry. How can stop this from happening? How can I minipulate just the selection as I once was able to do?

Am I using the wrong tool? Is this a setting I have triggered?
I know it's probaly something small and stupid.

Attached Images
# 2 08-02-2014 , 04:40 PM
sampson01's Avatar
Subscriber
Join Date: May 2006
Location: Williamson, WV
Posts: 121
double click the translate tool in the toolbox and uncheck "soft select".


Sampson
# 3 08-02-2014 , 08:40 PM
Gen's Avatar
Super Moderator
Join Date: Dec 2006
Location: South FL
Posts: 3,522
This question comes up extremely often. Might want to check out Stwert's FAQ thread and mine while you're at it.


- Genny
__________________
::|| My CG Blog ||::
::|| My Maya FAQ ||::
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads