extruded surfaces

Beer glass scene creation

This course contains a little bit of everything with modeling, UVing, texturing and dynamics in Maya, as well as compositing multilayered EXR's in Photoshop.

Watch

# 1 11-06-2003 , 03:05 PM

Subscriber
Join Date: May 2003

Location: Campinas - SP - Brazil

Posts: 30

Hello

I am trying to extrude a surface using a CV curve and a path. The path is a 3-sided square, completely ortogonal. My problem is in the curve.

It's CVs are not all in the same plane, and the curve seems to be a little inclined relative to the side and top planes. Then when I extrude it, the resulting surface is non-linear, with its width varying along the path.

I was wondering if there is a tool to make all the CVs to reside on the same plane and the curve to be paralell to a given plane.

Thanx in advance!!
Daniel

Quote

# 2 17-06-2003 , 03:23 PM

Registered User
Join Date: Dec 2002

Posts: 11

I may give you a partial response. If you want to have all your CVs on a ingle plane try utilizing your Vertex snap constrained to a single axis. Also, you could select all your CVs and snap them together (also on a single axis constraint) to a grid, curve or another vertex.
I also have problems pertaining non uniform extrusions and I am yet to find an answer

Quote

Reply to this thread