how do i make an arch? - Page 2 - Simply Maya User Community

Maya for 3D Printing - Rapid Prototyping

In this course we're going to look at something a little different, creating technically accurate 3D printed parts.

# 16 15-01-2004 , 03:46 PM

Vampus

Guest

Posts: n/a

I'd just create a poly cube and a poly cylinder, positioned the cylinder where I wanted the arch to go, merge the two, and just delete the un-needed bits.

Quote

# 17 16-01-2004 , 12:58 AM

Subscriber
Join Date: Mar 2003

Location: with PonysGirl

Posts: 2,573

PureMorning has a very good example of when booleans are the best. They do have there place for sure.. when the 2 objects are very well matched in typology, and its a clean mesh after.

the 2 main reasons against booleans:

Its hard to know if there going to work in situations where they are not matched well. So if your trying to used them allot, there is a lot of frustration and time wasted trying to make them work. They often don't work because the meshes don't sit will with each other.

Because it leaves you with a very tangled mesh. Buy the time you get done cleaning it all up or making it work it would have bean simpler and more accurate to extrude or some other of your favorite poly tools..

I could illustrate in pic’s if anyone is interested..

Quote

Reply to this thread