Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 19-07-2004 , 03:47 PM
Kaydray's Avatar
Registered User
Join Date: Jul 2004
Location: rhode island, USA
Posts: 46

creating Geometry constraints

hullo all-

can you create geometry constraints only in object mode or is there a way to select components (i.e. faces) of a mesh and constrain those?
i've tried but it tells me it is invalid- I guess the problem is that selecting multiple components means that it can't determine which are supposed to be targets and which are supposed to be constrained- is there a way around this?

thanks,
katie


-katie

"a foolish consistency is the hobgoblin of little minds." - rwe
# 2 19-07-2004 , 03:51 PM
mtmckinley's Avatar
The Maya Mountain
Join Date: Aug 2002
Location: Seattle, WA
Posts: 8,245
You can select components and create a cluster (animation module > Deform > create cluster).

But, I don't think the entire object will follow, though. If you want to constrain an object at a certain point like that, put its pivot point there.

# 3 19-07-2004 , 06:55 PM
Kaydray's Avatar
Registered User
Join Date: Jul 2004
Location: rhode island, USA
Posts: 46
perfect, thanks mike.

i wanted to put several constraints on the same mesh, so that worked out.

ciao ciao
katie


-katie

"a foolish consistency is the hobgoblin of little minds." - rwe
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads