Wierd Extrude Edges

Integrating 3D models with photography

Interested in integrating your 3D work with the real world? This might help

Watch

# 1 03-02-2005 , 07:03 PM

Subscriber
Join Date: Jun 2004

Location: Nottingham

Posts: 344

I am having a problem when building a car that when i try to extrude the edges anywhere on the front of the car including doors it seems to set the pivot someplace stupid instead of along the first where if i do the same thing on the back it sets the pivo correctly and orrentates it as well, why wont it do this on the front

Here an image of the front

Pivot marked in red
Extruded edge marked in yellow

Attached Thumbnails

Click image for larger version

Name: pivot_1.jpg
Views: 312
Size: 235.5 KB
ID: 19469

Quote

# 2 03-02-2005 , 07:06 PM

Subscriber
Join Date: Jun 2004

Location: Nottingham

Posts: 344

Here is what I want to happen but this only happens on the rear of the car

Attached Thumbnails

Click image for larger version

Name: pivot_2.jpg
Views: 298
Size: 160.6 KB
ID: 19470

Quote

# 3 04-02-2005 , 02:29 PM

Moderator
Join Date: May 2003

Location: London

Posts: 1,001

hit insert and check if the pivot is locked.

FX supervisor - double negative

Quote

# 4 04-02-2005 , 02:31 PM

Subscriber
Join Date: Jun 2004

Location: Nottingham

Posts: 344

ok I have it sorted I had to model the whole thing again but at least it is sorted must have been something I did first time round that screwed it up

Thanks
Rob

Quote

Reply to this thread