Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I think it can be done by saving as a *.ma file, and hope that you didnt use any version 4.0 features. But you will get an error message when you import it in to 3.5, just ignore that and re-save.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off