Nurbs Attaching Problem

Digital humans the art of the digital double

Ever wanted to know how digital doubles are created in the movie industry? This course will give you an insight into how it's done.

Watch

# 1 06-09-2005 , 05:10 PM

Subscriber
Join Date: Oct 2004

Posts: 7

I have been working on the rear end of a Porsche Boxter and I cannot get all my surfaces to attach right. I have detached and re-attached so many times I'm about ready to pull my hair out.

Every time I re-attach a surface, it changes the uv count of the original geomerty. Consequently, when I go to attach this new surface to yet another, the CV's don't match and it tweeks out uncontrobally. I have tried rebuilding using Match Knots, but the rebuild is just as tweeked out.

Can someone out there explain to me why my ispoarms line up beautifully, yet my UV count is way off, and how to change it? What can I do do keep surfaces from changing as I re-attach them?

Thanking you in advance,
Phil

PS: I have enclosed an attachment of the rear of my car. The Top section has a uv count of 5-14, the middle is 3-20, and the butt piece is a whopping 7-36, yet all my isoparms line up great. (????)

Attached Files

boxstertrunk.mb (39.7 KB, 270 views)

Quote

# 2 07-09-2005 , 02:57 AM

Registered User
Join Date: Dec 2004

Location: Melbourne, Australia

Posts: 36

From what I can see initally

1. You have different normal directions for your nurbs surfaces, to find out their direction click on the surfaces you wish to join and go to Display -> Nurbs Components -> Normals.
To fix this you need to use Edit Nurbs -> Reverse Surface Direction -> Option Box and choose either U V or both depending on the values of your surface.

2. I'm not sure wheather you know but just in case you don't to join two surfaces you need to have either the same amount of divisions on the surface or at least one side have multiples of two of the other side.

Adam

Quote

Reply to this thread