Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I'm not sure if anyone else is having this problem, but I seem to keep getting the message "The page cannot be displayed" whenever I try to access the page. If no one else is having this, it could be my firewall settings..... ... ..?
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off