Introduction to Maya - Rendering in Arnold
This course will look at the fundamentals of rendering in Arnold. We'll go through the different light types available, cameras, shaders, Arnold's render settings and finally how to split an image into render passes (AOV's), before we then reassemble it i
# 1 28-08-2006 , 05:56 AM
parka's Avatar
Registered User
Join Date: Aug 2005
Posts: 102

Creating carved text

How would you create craved text? E.g. Like the carved text off a tombstone.

How can I make use of the Create Text tool inside Maya for this?


Last edited by parka; 28-08-2006 at 06:08 AM.
# 2 28-08-2006 , 06:03 AM
parka's Avatar
Registered User
Join Date: Aug 2005
Posts: 102
I tried using the Create Text in the menu to create some text.
Then I extruded the curves to make them into polygons.

When I boolean difference with the tombstone, everything disappears!
I've check the normals which were all facing out. Maybe it's too complicated for boolean?

# 3 28-08-2006 , 10:28 AM
blackstrings's Avatar
Registered User
Join Date: Apr 2006
Location: United Sates
Posts: 79
not sure if it'll work, but did you try booleaning just one text at a time? and while soing so, try to make the text thicker and just insert it like 1/4 into the tombstone.

Otherwise, if it doesn't work, try this technique. put the text letters in place. > go to front view where you can see a view facing it front on. THen use the split polygon tool and trace the otuline of the text onto the tombstone > then use split polygon again to add in lines where there should be lines and > extrude. Hope that helps, although it will take longer to do it this way.


9 months into Maya...and still learning...
0 experience with any other 3D programs
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads