Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 24-11-2007 , 03:36 PM
Registered User
Join Date: Mar 2007
Posts: 1,055

Key tools in nurbs modeling?

Hi,

never tried it seriously and wondering, what are the tools you use the most in your projects? Like, in polygon modeling, I would say the key tools are the split polygon tool, insert edgeloop tool, and the merge tool.

cheers,

gubar

# 2 10-12-2007 , 04:10 PM
NeoStrider's Avatar
Registered User
Join Date: Jun 2004
Location: Cleveland, Ohio (USA)
Posts: 1,541
those would probably be the cv or ep curve tools, birail, loft, revolve, extrude, etc.


Accept no substitutions.
# 3 25-12-2007 , 09:07 AM
Falott's Avatar
Registered User
Join Date: Jan 2005
Location: vienna
Posts: 1,095
what I constantly use are those (try to get it kind of sorted according to my workflow)

EP curveTool

loft, revolve
birail - somtimes surface fillet

rebuild curve/surface
attach/detach curve/surface


project curve on surface
trim surface
duplicate surface curve
loft - rebuild again until i get clean patches

insert isoparms + tweak verts by hand
i use rebuild on curves and surfaces a lot!


everything starts and ends in the right place at the right time.
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads