Problem with NURBs booleans

Introduction to Maya - Modeling Fundamentals Vol 2

This course will look in the fundamentals of modeling in Maya with an emphasis on creating good topology. It's aimed at people that have some modeling experience in Maya but are having trouble with complex objects.

Watch

# 1 07-05-2008 , 12:40 PM

Registered User
Join Date: May 2008

Location: Southern California

Posts: 2

*What's the problem?

I have attempted to use a boolean to cut out part of a NURB cylinder, however it will not do anything. I don't have the problem if I use polygons but polygons aren't supported by the system the model will be used in.

*What happened when the problem occured?

Absolutely Nothing, unfortunately, not even an error message.

*What were you doing when the problem arose?

Trying to use boolean difference command (then all of the other boolean commands just to check)

*What are your system specs?

4GB RAM, 3.0GHz (x4) processor, 1GB VRAM, Windows Vista Ultimate

*What version of Maya are you using?

Maya 8.5 Unlimited

Any ideas as to what I can doot fix this? Maybe a MEL script to solve the problem?

Last edited by Silent.Samurai; 07-05-2008 at 01:23 PM.

Quote

# 2 07-05-2008 , 01:53 PM

Jr.Who

Guest

Posts: n/a

You can't use booleans on NURBS.

Quote

# 3 07-05-2008 , 02:31 PM

Registered User
Join Date: Jun 2004

Location: Cleveland, Ohio (USA)

Posts: 1,541

if you need to remove a section of a nurbs cylinder, perform a trim.

at the objects' intersection you can project a curve on surface (from the other object) and then proceed with the trim.

Accept no substitutions.

Last edited by NeoStrider; 07-05-2008 at 02:42 PM.

Quote

Reply to this thread