Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Some of the video tuts says to be in modeling mode, however,
In my status bar is shows Polygon, Surface, Dynamics, etc.
How do I set the Setting Preferance windoow to show modeling model.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off