My first finished project : Final Fantasy X-2 Rikku's Weapon

Maya for 3D Printing - Rapid Prototyping

In this course we're going to look at something a little different, creating technically accurate 3D printed parts.

Watch

# 1 25-01-2003 , 06:59 PM

Subscriber
Join Date: Dec 2002

Location: Greece - Chalkida

Posts: 138

My first finished project : Final Fantasy X-2 Rikku's Weapon

This is as close as i could get.
I think my version is better than the ps2's one. :-)
Please criticize my work..!

Ioannis KarAvas

Quote

# 2 26-01-2003 , 12:17 AM

Subscriber
Join Date: Aug 2002

Posts: 1,135

I must say that the knife looks pretty good.

Can you tell me about the hardest part (if any)? I'm just curious and try to pick up on polygonal work

I do not support Bush! Nor Saddam! Long live UN!

Quote

# 3 26-01-2003 , 07:54 AM

Subscriber
Join Date: Dec 2002

Location: Greece - Chalkida

Posts: 138

well all of the parts were hard if you think that i almost didn't know anything about poly-manipulation...but finally found out many things...
the blade started somehow like this: curves->planar (poly)->then designed on the blade the line that bumps a little up..using poly-spilt and then just selected the faces of the line and translate it a little higher and it started looking like a blade..(of course i did a little more tweaking later..)
As for the white spots..it is 3d paint, airbrush.

É don't think polys are so great (maybe later in the project they seem better), i first use nurbs and then convert them to polys.

Ioannis KarAvas

Last edited by AbsolutelyWhite; 26-01-2003 at 08:02 AM.

Quote