Introduction to Maya - Rendering in Arnold
This course will look at the fundamentals of rendering in Arnold. We'll go through the different light types available, cameras, shaders, Arnold's render settings and finally how to split an image into render passes (AOV's), before we then reassemble it i
# 1 16-05-2015 , 09:04 PM
Registered User
Join Date: May 2015
Posts: 3

Help, Edge Slide and snap to other meshes

Hi All

I am coming to Maya from Max for a new job and I have a question. I am trying to move an edge along an angle and aligning that edge to another mesh in the scene. In max I would use edge constraint the snap the edge to the other mesh. The edge would snap to the required height while sliding along the mesh constrained to the edge. In maya whenever I attempt to snap the edge constraint is disabled and thus the edge doesn't slide it just deforms the mesh to align the edge to the mesh I am snapping to.

In short I am using the constraint in Maya "Transform Constraints - Edge" which works fine but disables when holding the V button for point snapping. I have tried the edge slide tool but the snapping option doesn't apply to other meshes. Any help would be greatly appreciated. Thanks!

Pic attached

Attached Thumbnails
# 2 16-05-2015 , 09:20 PM
Registered User
Join Date: May 2015
Posts: 3
Forgot to add that this is Maya 2014

# 3 17-05-2015 , 07:57 PM
jsprogg's Avatar
Lifetime Member
Join Date: Feb 2004
Location: Chicago
Posts: 1,712
One way to do this is to select the edge with the slide edge loop tool then hold down the v key and middle mouse drag across one of the top vertices of the cylinder and the edge will slide to the vertex height.




2 x Modeling Challenge Winner
# 4 18-05-2015 , 01:31 AM
Registered User
Join Date: May 2015
Posts: 3

One way to do this is to select the edge with the slide edge loop tool then hold down the v key and middle mouse drag across one of the top vertices of the cylinder and the edge will slide to the vertex height.

Thanks for your response. Unfortuantley I've tried that method and it does not work. The edge will snap at increments but it will not snap to the other meshes height or whatever you are aiming for. Any other ideas?

Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads