Well, I am trying to get a simple car mesh with lights, front side. I´ve done the following steps:
1. Create a PolyCube
2. Convert Poly --> to SubDiv
3. SubDiv Surfaces --> Full Crease Edge/Vertex
Question 1:
Is it possbile to set the strength of the crease per hand ?
--> I mean, can I set different values ?
Question 2:
On the images below you can see the strange distortion on the edges from the lights.
How can I avoid that ?
thank you soo much for helping me,
bernhard
. You can do a partial crease Edge/Vertex but that is exactly half-way between full crease and no crease. A way that I have used is to refine the mesh (add some more edges close to the one to be creased) then do a partial crease on the edge - it will come out sharper. You need to play around a bit to find what works best.
