help with create polygon tool

Introduction to Maya - Modeling Fundamentals Vol 2

This course will look in the fundamentals of modeling in Maya with an emphasis on creating good topology. It's aimed at people that have some modeling experience in Maya but are having trouble with complex objects.

Watch

# 1 01-09-2003 , 07:20 PM

Registered User
Join Date: Aug 2003

Location: Vienna, VA

Posts: 25

I was working with the Create Polygon tool....and when I create one, it's always filled with pink and I need it to be transparent. any help would be appreciated. user added image

Attached Thumbnails

Click image for larger version

Name: help.jpg
Views: 589
Size: 212.1 KB
ID: 10270

Quote

# 2 01-09-2003 , 07:30 PM

The Maya Mountain
Join Date: Aug 2002

Location: Seattle, WA

Posts: 8,245

At this point, you press Enter for it to finalize creating the object. Then you can assign it a transparant material.

-Mike
The Maya Toolbelt

Quote

# 3 01-09-2003 , 07:41 PM

Moderator
Join Date: Nov 2002

Location: New York

Posts: 2,133

If you don't want to see the pink as you're creating the shape, just make sure you're viewing in wireframe (hit the "4" key) rather than shaded mode ("5" key).

"Terminat Bora Diem, Terminal Auctor opus."

Quote

# 4 01-09-2003 , 07:42 PM

Registered User
Join Date: Aug 2003

Location: Vienna, VA

Posts: 25

but I need to see through it when I'm modeling and sometimes the pink area blocks my view of the drawing below. So is it possible to have it transparent while working on it? I also need to see the drawing and when I hit 4 the drawing disappears.

Last edited by gueedo; 01-09-2003 at 07:44 PM.

Quote

# 5 01-09-2003 , 07:45 PM

The Maya Mountain
Join Date: Aug 2002

Location: Seattle, WA

Posts: 8,245

Well, there's no rule against hitting enter and then changing the shape afterwards by moving points around.

-Mike
The Maya Toolbelt

Quote

# 6 01-09-2003 , 07:56 PM

Subscriber
Join Date: Feb 2003

Posts: 1,254

If you want to be able to see through it, as required by some tutorials, you can, once it is a finished face, go to shading/shade options/ and check the xray heading. That lets you see through a semi transparent version of your shape to what is underneath.

Quote

# 7 01-09-2003 , 07:59 PM

Registered User
Join Date: Aug 2003

Location: Vienna, VA

Posts: 25

alright I think I got it now...thanks for the advice. The responses on this board have got to be the fastest I've seen on any BB. Thanx again user added image