Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
i was woundering if anyone had a link for this kind of head modeling.this was as far as i can get trying ti figure it out on my own.anything would help.i think this way is alot better than my current method.thank you.i dont even know what method this is called.just extruding alot of edges.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off