Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
#
1
02-01-2009
, 11:25 PM
Registered User
Join Date: Oct 2008
Join Date: Oct 2008
Location: germany, nürnberg
Posts: 15
Extruding Curves along path always screws up!!!
this is my first post here so sorry if i ask such a noob question:
i want to extrude a windowprofile from a nurbs curve. it should go along a path (which is of course a rectangular), and so it does.
the problem is, it always screws up at the connention point, where start and end of the rectangular meet.
i closed both of the curves (profile and path) and tried every possibility in the extrude option box.
i'll attach a picture so you can see what i'm talking of.
i also tried putting the connection point of the rectangular on the line between two points. same result. for some reason the extruded tube never fits at the connection point.
please help me out
thanks a lot
#
2
03-01-2009
, 05:42 PM
Moderator
Join Date: Jan 2004
Join Date: Jan 2004
Location: Michigan, USA
Posts: 2,998
1. Create a nurbs square
2. Create a profile curve and center its pivot
3. using curve snap place the profile at one of the corners at a 45 degree angle
4. then duplicate the profile placing the duplicates at the remaining 3 corners also at 45 degrees
5 then just loft each side
6. when you have all the sides lofted you can attach the four sides if you desire a single piece of geometry
step 1 and 2 and 3...
Last edited by ctbram; 04-01-2009 at 04:48 AM.
#
3
03-01-2009
, 05:49 PM
Moderator
Join Date: Jan 2004
Join Date: Jan 2004
Location: Michigan, USA
Posts: 2,998
Last edited by ctbram; 04-01-2009 at 04:47 AM.
Posting Rules Forum Rules
Similar Threads
EXTRUDING EDGE ALONG A PATH
by rejh2 in forum Maya Basics & Newbie Lounge replies 1 on 10-05-2009
Extruding curves
by amoeba in forum Maya Basics & Newbie Lounge replies 7 on 22-06-2008
help extruding along path
by oompa_l in forum Maya Basics & Newbie Lounge replies 0 on 26-06-2007
Extruding along a path
by mshoward82 in forum Maya Modeling replies 3 on 20-06-2003
Extruding Curves question
by NitroLiq in forum Maya Modeling replies 11 on 16-12-2002
Topics
New tutorial - Create tileable textures from photos. Photoshop to Alchemist to Maya 2
By David
Site News & Announcements
3
Free Courses
Full Courses
VFX News
How computer animation was used 30 years ago to make a Roger Rabbit short
On 2022-07-18 14:30:13
Sneak peek at Houdini 19.5
On 2022-07-18 14:17:59
VFX Breakdown The Man Who Fell To Earth
On 2022-07-15 13:14:36
Resident Evil - Teaser Trailer
On 2022-05-13 13:52:25
New cloud modeling nodes for Bifrost
On 2022-05-02 20:24:13
MPC Showreel 2022
On 2022-04-13 16:02:13