>>> Reversing the Sweep Angles on an Extruded Surface <<<

Introduction to Maya - Modeling Fundamentals Vol 2

This course will look in the fundamentals of modeling in Maya with an emphasis on creating good topology. It's aimed at people that have some modeling experience in Maya but are having trouble with complex objects.

Watch

# 1 08-03-2005 , 12:58 AM

Registered User
Join Date: Jan 2005

Location: I live inside my computer

Posts: 79

>>> Reversing the Sweep Angles on an Extruded Surface <<<

I made a curve and extruded it, and the start/end sweep angle (darker isoparm/like) is on the side. I want to attach it to a different extruded surface that has the line in a different place. I can't rotate the tube because it is wavy and stuff. How can I change the place of the dark isopram (sweep angle thing).

Thanx a lot!!! user added image

Imagination is more important than knowledge...
--Albert Einstein

Quote

# 2 08-03-2005 , 02:55 AM

Subscriber
Join Date: Sep 2004

Location: Waianae, HI

Posts: 1,275

You could select an Isoparm where you want the seam and then detach the surface. Granted, this will give you two surfaces where you had one, but you could always go back and reattach the loose surface.

AIM: mhcannonDMC

"If you love your job, you'll never work another day in your life."

Quote

Reply to this thread