Attaching Two Surfaces Together

Introduction to Maya - Rendering in Arnold

This course will look at the fundamentals of rendering in Arnold. We'll go through the different light types available, cameras, shaders, Arnold's render settings and finally how to split an image into render passes (AOV's), before we then reassemble it i

Watch

# 1 26-11-2005 , 12:47 PM

Registered User
Join Date: Nov 2005

Posts: 4

Hi,

I have what should be a very simple problem, but I cannot work out how to do it.

Basically, if I create a sphere (NURBS) and intersect it through the middle with a vertical plane and trim out half of it.

I then duplicate it with a -1 scale factor for the x to produce the other half. Now, I wish to attach these two hemispheres together, but whenever I select both of them and click attach it doesn't do it. I have tried reversing the surface directions but to no avail.

Anybody have a solution?

Quote

# 2 27-11-2005 , 01:16 AM

Subscriber
Join Date: Sep 2002

Location: Chicagoland USA

Posts: 719

Can you post the file please?

<html><font size=2>
<font color="blue">
And after calming me down with some orange slices and some fetal spooning,
E.T. revealed to me his singular purpose.

--TOOL, 10,000 Days---

</font></pre>
</html>

Quote

# 3 27-11-2005 , 09:57 AM

Registered User
Join Date: Nov 2005

Posts: 4

Here is the file. I need these two hemispheres to be attached together into one surface. ( i know in this simple case this could be done by creating a sphere).

Note its Maya 7.

Thanks.

Attached Files