Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I am having trouble adjusting the tangents in the graph editor. I have a pully system which i am trying to animate, and to begin with I want this pully to just rotate a few times. I have set this rotation up, but the line on the graph editor is just a straight line. I want to ease in and out of the rotaion, so it slower to start, speeds up, and then slows a bit more at the end. I have selected the tangent handles, and i know how to break them, but when I have the handle selected, I hold down and try and mmb drag it, or just mmb drag it without shift, but the tangent handle stays put. Is there another button from the baove toolbar I should have selected?
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off