Maya for 3D Printing - Rapid Prototyping
In this course we're going to look at something a little different, creating technically accurate 3D printed parts.
# 1 26-01-2012 , 09:55 PM
Subscriber
Join Date: Aug 2005
Location: Austin, TX
Posts: 496

reverse foot control issues


# 2 27-01-2012 , 06:53 PM
puneet.3d's Avatar
Lifetime Member
Join Date: Aug 2008
Posts: 78
well i think. you are making a small mistake. follow this tutorial carefully its bit more complicated. make sure all joints are names as they are named in the tutorial and make sure all the constraints you apply are correct. first you try this tut again carefully. if you still not getting it. then i will tell you one another method much more simpler than this one user added image

# 3 28-01-2012 , 07:18 PM
Subscriber
Join Date: Aug 2005
Location: Austin, TX
Posts: 496
well i think the difference between this tut and mine is that they're using block objects and mine is a single full model. I've gone back and followed the tut again but i'm still getting a funky setup.

Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads