Duplicate Special wont obey
Hello, I tried pretty hard to fix this issue by searching existing results here without posting a new thread but that was a confusing fail so here I am.
I am modeling a fighter plane. Tutor instructs to use duplicate special to mirror one side of the plane. I dupe special one half of the plane
Put everything to Geo type: instance. Group under: parent. Translate: 0 Rotate: 0. Scale: x-1
After I dupe special and try to work on it the 2 separate pieces of plane act independent of each other.and the work i do does not affect both pieces.
Other uses posts i checked here with the same kind of problem had these suggestions from others that i tried to fix my own problem.
Tried deleting history
made sure everything set to 0 and centered to grid.
Move settings: axis orientation set to world
make sure retain component spacing is un checked
Mirroring geo/poly does not not work because you cant work on both sides of plane at the same time after.
There is some other ideas i tried that were suggested but i cant remember them all as this is rather confusing
Thanx
Last edited by liquidcactus; 19-09-2017 at 01:24 PM.