(polygons)
I try to make a hole in my object.. I have a cylindershape(thecuttingobject) and a boxylooking object where the cut needs to be done..
I've tried to look for anything, but found nothing...
thkz already for helping me out!
Introduction to Maya - Rendering in Arnold
This course will look at the fundamentals of rendering in Arnold. We'll go through the different light types available, cameras, shaders, Arnold's render settings and finally how to split an image into render passes (AOV's), before we then reassemble it i
#
1
05-04-2004
, 11:14 AM
Subscriber
Join Date: Feb 2004
Join Date: Feb 2004
Location: Amsterdam
Posts: 731
cutting a object with another
(polygons)
I try to make a hole in my object.. I have a cylindershape(thecuttingobject) and a boxylooking object where the cut needs to be done..
I've tried to look for anything, but found nothing...
thkz already for helping me out!
...
#
2
05-04-2004
, 11:57 AM
Moderator
Join Date: Oct 2002
Join Date: Oct 2002
Location: London, UK
Posts: 2,800
Here's an example:
Say you have a cylinder with 8 sides (for this the lower the better) you need to have enough cuts in the other mesh to accommodte the sides. So If I made a cube I would have to make sure I had 5 cuts around the y axis and 5 around the x axis. These need to then be moved so that they line up with the verts of the cylinder object. Do the same on the other axis. Then you need to do the boolen (difference) bectween the two objects and you should get a relatively clean mesh. Then you need to vertex snap any stray verts together and merge them to get a clean mesh.
See the scene file I've attached for a better idea of what I mean. It's a massive pain in the arse believe me but it's the only way to get good results that are usable afterwards!
