Gaps in NURBS model
I'm using NURBS to make a computer keyboard key but am getting strange gaps in my model.
I created this model by using extruded curves and then Circular Filleting a plane on top, then Trimming it.
I've done the whole Render / Set NURBS Tessellation / High Quality / UV Division Factor 5.00 gig but still getting a slight gap in my model.
Any suggestions?
"Please excuse the crudity of this model, I didn’t have time to build it to scale or to paint it"
:: Dr. Emmett Brown
Last edited by sjurick; 14-04-2004 at 11:12 PM.