Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I have what should be a very simple problem, but I cannot work out how to do it.
Basically, if I create a sphere (NURBS) and intersect it through the middle with a vertical plane and trim out half of it.
I then duplicate it with a -1 scale factor for the x to produce the other half. Now, I wish to attach these two hemispheres together, but whenever I select both of them and click attach it doesn't do it. I have tried reversing the surface directions but to no avail.
<html><font size=2>
<font color="blue">
And after calming me down with some orange slices and some fetal spooning,
E.T. revealed to me his singular purpose.
Here is the file. I need these two hemispheres to be attached together into one surface. ( i know in this simple case this could be done by creating a sphere).