Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I'm working on a character, and deleting, extruding and appending etc.
I have a problem now that changes I make to the surface material only affect new faces - all the original faces remain the same colour, transparency etc. I've tried assigning new materials but no change - only the new faces are affected.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off