Now on the problem:
I created a curve using the CV Curve tool then tried to apply extrude (surface) on the curve by previously selecting a NURB circle so I could hopefully apply geometry to that curve using the circle as a reference (correct me on that if necessary), however the opposite happened, even though I had shift-selected NURB circle > Curve, the curve was applied to the circle and generated itself into a random curve with geometry.
In a long shot, I tried to access the Outliner window in order to see if there was some priority issue but alas I couldn't understand if that was the case.
So that's my current problem, unfortunately I'm not able to advance into my tutorial until I manage to get this sorted, I hope any of you will be able to lend me a hand on this, thank you!
