Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
oh ok, that does not work easy. and it might not always work. there is a way to save the file as ascii (.ma) and then editing it by hand so that it does not say it is a 5.0 file no more.
there is a thread somewhere that describes that - but i dont know exactly where. maybe you try the search. and others might have found this later and direct you to the right thread.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off