Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Could someone please tell me why when smoothing a sphere
and changing the above node to has no effect it fails to revert
to its original state, This is in V8 or am I doing this wrong
the same procedure worked in V7.
it its set to no effect its not calculating something, kinda like deleting the history. It knows its there its just not useing it. you need to turn it back on before you can remove it or it will give you problems.
its kind of like futsing with IKs and moving the pivot point on the wrong anchor and having the chain freak out. you cant undo it because it didnt register the change in the history.
simplar principal but a diffrent problem.
i would also like to say that I have a VERY limited knowlege of how to use those values so if i'm blowing smoke its just because I have bad information ^^;
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off