Introduction to Maya - Rendering in Arnold
This course will look at the fundamentals of rendering in Arnold. We'll go through the different light types available, cameras, shaders, Arnold's render settings and finally how to split an image into render passes (AOV's), before we then reassemble it i
# 1 03-07-2007 , 03:59 AM
pbman's Avatar
Subscriber
Join Date: Mar 2005
Location: London
Posts: 1,135

layered shader

hey im following a tut

on a layered shader u plug in the file then it says set its blend mode to multiply or other settings but i cant find where to change this

any ideas?

thx


Now at SMU doing BSc 3D Computer Animation so its hard to get on here
My wire render tut https://forum.simplymaya.com/showthre...threadid=20973
# 2 03-07-2007 , 04:42 AM
oldhippie_tom's Avatar
Subscriber
Join Date: Sep 2005
Location: Palm Springs, Ca
Posts: 459
I hope this helps and it was what you were looking for.

Attached Thumbnails

Challenge me and I will try. Because If I should fail, failure also has a prize (Knowledge).
# 3 03-07-2007 , 04:52 AM
pbman's Avatar
Subscriber
Join Date: Mar 2005
Location: London
Posts: 1,135
yes thx

i was looking under layered shader for it

it was under a layered texture node


Now at SMU doing BSc 3D Computer Animation so its hard to get on here
My wire render tut https://forum.simplymaya.com/showthre...threadid=20973
# 4 03-07-2007 , 05:05 AM
oldhippie_tom's Avatar
Subscriber
Join Date: Sep 2005
Location: Palm Springs, Ca
Posts: 459
Have to say it took me few minutes also!!


Challenge me and I will try. Because If I should fail, failure also has a prize (Knowledge).
# 5 03-07-2007 , 08:44 PM
gster123's Avatar
Moderator
Join Date: May 2005
Location: Manchester Uk
Posts: 6,300
Have a look into the Mix20 shader for mental ray, works similar but its much better


"No pressure, no diamonds" Thomas Carlyle
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads